| In open fields, forests, and wetlands,
most rain is absorbed by the soil or is taken up by plants and trees. In
developed areas, rain that falls on impermeable roofs, parking lots,
streets, and lawns is not absorbed. Instead, it travels down roadways,
settles in gutters and ditches, and flows through storm drains to finally
end up in rivers, lakes, and wetlands. Rainwater that enters a surface water
body, by flowing either overland or through a storm sewer system, is called
storm water or storm water runoff. Storm water
runoff is one of the leading causes of pollution in rivers and lakes. In
both urban and agricultural settings, it can dissolve and transport a
variety of chemicals, fertilizers, pesticides, and litter picked up while
traveling overland. Identifying sources of storm water pollution and keeping
them from coming in contact with runoff is the best and most economical way
to protect the quality of the nation's waters.
Tests conducted by EPA on fluid samples from service
station floor drains indicate that improper disposal of waste generated
during vehicle servicing poses the threat of surface water contamination.
Waste oil, antifreeze, and solvents are washed into floor drains which are
improperly disposed into separate storm drains. EPA prohibits the discharge
of wastewaters into separate storm sewers and permits certain storm water
discharges under the authority of the Clean Water Act.
In most cases, typical fluid samples exceed EPA's
criteria for identifying properties or characteristics that define a waste
as hazardous under the Resource Conservation and Recovery Act (RCRA).
Benzene and a number of chlorinated solvents are among the 25 chemicals that
have been added to EPA's Toxicity Characteristics list under RCRA.
In addition, any facility that generates more than 27
gallons of wastewater per month containing any of the listed chemicals in
amounts exceeding EPA's regulatory levels needs either to recycle the
material or to dispose of it as hazardous waste. Facilities that generate
less than 27 gallons of wastewater per month are conditionally exempt.
- To meet the requirements of Section 402 of the
federal Clean Water Act, most states have developed State Storm Water
Discharge Permit Programs. Check with your state environmental agency to
determine if stormwater runoff or stormwater discharged from your facility
requires an NPDES permit. There are three categories of storm water
discharges to be regulated by NPDES permits:
- Storm water associated with industrial
activity
Facilities that engage in regulated
industrial activities are typically required to develop and implement
storm water pollution prevention plans. Many industrial storm water
discharges may be covered under general permits.
- Storm water from construction sites disturbing
over 5 acres
Owners of construction activities which
disturb five or more acres must develop and implement construction site
erosion control and storm water management plans. Most construction
activities are eligible for coverage under state-issued general permits.
- Discharges from municipal separate storm
sewers serving populations over 100,000
Operators of municipal separate storm sewer
systems (MS4s) must develop and implement storm water management plans
to reduce pollutant loadings to the maximum extent practicable, and must
investigate and eliminate illicit connections to the storm sewer system.
Click here to open this page in the EPA website |
Providing
Excellent Products and Customer Service Since 1985
xml